Recommended
by your knees.

Scroll down info iconScroll down info icon

Discover the right PROTECTOR model for you!

  1. Product overview - PROTECTOR PR 13 GW SET
    PROTECTOR PR 13 GW SET Alpine Bindings
    In stock
  2. Product overview - PROTECTOR PR 11 GW SET
    PROTECTOR PR 11 GW SET Alpine Bindings
    In stock
  3. Product overview - PROTECTOR SLR 11 GW SET
    PROTECTOR SLR 11 GW SET Alpine Bindings
    In stock
  4. Product overview - PROTECTOR ATTACK 13 MN
    PROTECTOR ATTACK 13 MN Freeski Bindings
    In stock

With 34% knee injuries sadly top the ranking of the most common ski injuries. They are mainly caused by backward twisting falls. In particular, additional studies have shown that women are two to three times more likely to injure the knee and ligaments than men (see Senner et al. 2014, bfu Report No. 69, Bern). Conventional bindings of all major suppliers are designed to reduce the risk of injuries to the lower leg below the knee, but they are not intended for preventing injuries to the knee.

 

Thanks to the innovative FULL HEEL RELEASE function, the new PROTECTOR binding can reduce ACL strain by more than 50%*. This can significantly reduce or mitigate the risk of knee injuries and injuries below the knee.

Protector Banner MobileProtector Banner Mobile

The new PROTECTOR binding thus offers you unprecedented safety and once again proves that you can better even the best.

*Finite element model simulations of the University of Innsbruck: "Lateral Heel Release Reduces ACL Strain in Simulated Backward Twisting Falls"

REDUCING AND
MITIGATING KNEE
INJURIES
SIGNIFICANTLY (ESPECIALLY ACL
INJURIES).

A skier on a wonderful ski slope.A skier on a wonderful ski slope.
Illustration eines RückwärtsdrehsturzIllustration eines Rückwärtsdrehsturz

BACKWARD TWISTING FALLS

The most common injuries in recreational skiing are knee injuries (especially ACL injuries). 75% are mainly caused by backward twisting falls.

PROTECTOR improves this situation!

In backward twisting falls the release values with PROTECTOR can be more
than 50% lower compared to a conventional binding.

Thanks to the reduced release values in the event of a backward twisting fall, the forces on the tibia and the ACL are reduced by more than 50 %. This decrease will finally lead to a significant reduction and mitigation of knee injuries and assures safer skiing.

These results are officially confirmed by independent studies completed at the University of Innsbruck.

Made in Austria. Skier in the Austrian alps.Made in Austria. Skier in the Austrian alps.

APPROVED BY THE
UNIVERSITY OF
INNSBRUCK.

How does it work

1. Low, short-term forces are absorbed by PROTECTOR's 7 mm of bilateral travel. Benefit: This elasticity avoids pre-releases.

 

2. Higher forces that exceed the release setting will move the heel the full 7 mm at which point PROTECTOR rotates open by 30° to release the ski boot.

SAME
PERFORMANCE
SAME COMFORT
MAXIMUM SAFETY.

RECOMMENDED BY YOUR KNEES
AND OUR SKI LEGENDS

Protector Product Range

Piste & All Mountain Segment

The PROTECTOR PR and SLR models are the perfect choice for all piste skiers, whether young or old, beginner or advanced.

PROTECTOR PR

If you do not want to compromise on high performance, you should choose the PROTECTOR PR 13 model with the RX toe for improved aerodynamic features. On the other hand, if you are an ambitious skier who wants to take advantage of the slopes under any condition, you should consider the PROTECTOR PR 11 with the TX toe.

The PROTECTOR PR models are based on a PowerRail base. These models work with all skis with a pre-mounted PR base. For all flat skis, we offer the PROTECTOR Set models.

PROTECTOR SLR

The new Protector SLR offers FULL HEEL RELEASE technology at a lower weight and stand height. Therefore, this binding is particularly suitable for lightweight and female skiers. Based on the SLR system, the Protector SLR works with all flat skis or skis with a pre-mounted SLR Pro base.

- Stand height of 28mm
- Compact and feminine design
- Low weight of only 975g

  1. Product overview - PROTECTOR PR 13 GW SET
    PROTECTOR PR 13 GW SET Alpine Bindings
    In stock
  2. Product overview - PROTECTOR PR 11 GW SET
    PROTECTOR PR 11 GW SET Alpine Bindings
    In stock
  3. Product overview - PROTECTOR SLR 11 GW SET
    PROTECTOR SLR 11 GW SET Alpine Bindings
    In stock

Attack Segment

The PROTECTOR Attack model combines the best of both worlds by bringing the Full Heel Release (FHR) technology to our Attack series.

FeaturesFeatures

LET US EXPLAIN

The ASTM testing machine is used to simulate various falls and measure the corresponding forces on the leg. In this clip you see the PROTECTOR being run through two of these tests, and how its test results compare to those of a conventional binding.

Questions & Answers

WHAT MAKES HEAD/TYROLIA’S BRAND NEW PROTECTOR BINDINGS SO REVOLUTIONARY?

As the world’s ski binding market leader, we at TYROLIA are thrilled to unveil PROTECTOR, the most safety-focused bindings yet. Thanks to Full Heel Release (FHR), our revolutionary 180-degree heel release mechanism, the PROTECTOR binding is currently the most effective binding at preventing serious knee injuries and reducing the risk of injury caused by backward twisting falls.

WHAT WAS THE STARTING POINT FOR THE DEVELOPMENT OF THIS INNOVATION?

Numerous medical and sports science studies show that knee injuries account for one-third of all injuries incurred in recreational skiing, with anterior cruciate ligament (ACL) damage being the most common knee injury. The backward twisting fall is known to be the main cause of these knee injuries. Our goal has been to improve this situation and reduce injuries through mechanical advancements in our bindings. This is why PROTECTOR is so thrilling – it is proven to reduce the risk of knee injury due to its Full Heel Release.

WHAT IS A BACKWARD TWISTING FALL?

Characteristically, a backward twisting fall presents the following elements: the center of the skier’s body is off balance (typically leaning back), a load is on the end of the ski, ligaments in the knee are pre[1]tensioned, and a catching inside edge causes an internal rotation of the tibia relative to the thigh. The ACL usually tears when the knee is fully loaded in this flexed position and rotated at the same time, or when the knee is hyperextended.

WHAT MAKES THE PROTECTOR DIFFERENT COMPARED TO CONVENTIONAL SAFETY BINDINGS?

Conventional bindings from all major suppliers are designed to reduce the risk of injury to bones in the lower leg. However, they are not suitable for preventing knee injuries. Since the 1980s, little has changed in technology and functionality in this regard, but injury patterns have. With the carving ski boom, the number of serious injuries to the knee - especially to the ligaments - has increased dramatically. This is mainly caused by backward twisting falls, which account for 70% of all falls. These injuries are what we focused on reducing.

WHAT NEW TECHNOLOGY IS FEATURED IN THE PROTECTOR?

Full Heel Release (FHR) technology is the centrepiece around which the PROTECTOR binding rotates – figuratively and literally. While conventional safety bindings only release vertically at the heel (and experience increased release values in backward twisting falls), FHR offers a combination of horizontal and vertical releases, allowing PROTECTOR bindings to maintain constant release values during backward twisting falls.

 

HOW DOES THE FULL HEEL RELEASE (FHR) WORK?

Low, short-term forces are absorbed by the 7mm of horizontal, bilateral movement of the heel. When the load exceeds the FHR settings, the heel slides horizontally the full 7mm and rotates open by 30 degrees to release the ski boot. This feature establishes a new benchmark in ski binding safety and functionality. Thanks to the more constant release values, the forces acting on the knee and its ligaments are reduced by more than 50%. With the PROTECTOR binding, TYROLIA thus achieves a significant reduction in the risk of knee injury in the event of a fall.

DOES THE NEW HEEL DESIGN AND THE RESULTING LOWER RELEASE VALUES FOR BACKWARD TWISTING FALLS AFFECT THE SKIER'S PERFORMANCE OR FEEL?

In a word: no. Five-time Kitzbuehel downhill winner Didier Cuche confirmed this during his on-snow tests. Despite the new movement found in FHR, there is no increase in the risk of pre-releases. The new features, including the 7 mm bilateral movement of the heel, are simply not noticeable while skiing. In addition to FHR, the new PROTECTOR binding offers all of TYROLIA’s industry-leading safety features along with on-snow performance that matches any other conventional TYROLIA binding.

HOW COMPLICATED IS IT TO SWITCH TO THE NEW FHR TECHNOLOGY?

The transition is very simple because the PROTECTOR binding can be quickly and easily utilized on any ski model with a pre-mounted Power Rail base. For all flat skis, TYROLIA offers the PROTECTOR Set versions as well as the PROTECTOR Attack model. This also benefits rental businesses that can easily offer the FHR technology for maximum safety.

FOR WHICH KIND OF SKIER IS THE PROTECTOR SLR SUITABLE?

Studies have shown that women are two to three times more likely to injure the knee and ligaments than men (see Senner et al. 2014, bfu Report No. 69, Bern). Thanks to the new PROTECTOR SLR lightweight, young skiers or ladies can count on lower stress and a reduced risk of knee injuries. The new PROTECTOR model brings enormous safety benefits for beginners, advanced and experienced skiers.

WHICH IS THE MAIN DIFFERENCE BETWEEN THE PROTECTOR MODELS?

The PROTECTOR PR and SLR models are the perfect choice for all piste skiers, whether young or old, beginner or advanced.

PROTECTOR PR
If you do not want to compromise on high performance, you should choose the PROTECTOR PR 13 model with the RX toe for improved aerodynamic features. On the other hand, if you are an ambitious skier who wants to take advantage of the slopes under any condition, you should consider the PROTECTOR PR 11 with the TX toe. The PROTECTOR PR models are based on a PowerRail base. These models work with all skis with a pre-mounted PR base. For all flat skis, we offer the PROTECTOR Set models.

PROTECTOR SLR
Compared to the PROTECTOR PR models, the PROTECTOR SLR has a significantly lower stand height of only 28 mm. Its design has been made more compact and feminine, with a weight decrease of 370 grams. The PROTECTOR SLR is best suited for all lightweight skiers looking for lighter but still powerful equipment. The latest addition to the PROTECTOR family is compatible with TYROLIA's SLR Base System and can be mounted on all skis with a pre-mounted SLR Pro Base. For all flat skis, you should check the PROTECTOR SLR SET models including the SLR Pro Base and bindings.

PROTECTOR Attack
Last but not least, the PROTECTOR Attack model is versatile and ready for use in any terrain by bringing the Full Heel Release (FHR) technology to our Attack series. The PROTECTOR Attack is the perfect choice if you're looking for a versatile, durable binding suitable for any terrain - piste, park, pipe, powder, etc. The PROTECTOR Attack model works with all flat and wide skis and is compatible with Alpine, Touring, and GripWalk ski boots.

* Finite-Element-Model-Simulations of the University of Innsbruck: „Lateral Heel Release Reduces ACL Strain in Simulated Backward Twisting Falls“